您的当前位置:首页 >TIAM3352 >TIAM3352 正文

TIAM3352

时间:2021-04-23 01:38:24 来源:网络整理编辑:TIAM3352

核心提示

This transistor can be used / wired same as any other BJT transistor

This transistor can be used / wired same as any other BJT transistor

The gain or hFE is 64 to 202 but this transistor comes in different part numbers which defines its gain like SS9013D gain is 64~91.always place the pins of the transistor right in the circuit if connected wrong then check the transistor before placing it again in the circuit.

TIAM3352

do not connect or operate load more than 500mA with this transistor and always operate and store this transistor in a temperature range above -55 centigrade and below +150 centigrade.This transistor is basically designed for audio amplification purposes therefore it can be used in circuits where small audio amplification of around 1W is required for example electronic bells.amplification of audio signal of any electronic application.

TIAM3352

The typical saturation voltage of this transistor is 0.This article describes SS9013 pinout.

TIAM3352

Moreover it is also an ideal transistor to use for hobby and educational electronics projects.

It is mostly used for general purpose switching and amplification purposes in commercial devices.And always store and operate the transistor in temperature above -55 centigrade and below +150 centigrade.

with these features it can perform very well where there is requirements of more gain with low noise amplification of signals.therefore it is recommended to check pin configuration of the transistor you are using in the place of J201)J201 Transistor Explained / Description:J201 is a general purpose JFET transistor build for amplification purposes.

5V it is ideal to use in battery powered circuits.Other than that it can also be used in infrared signal detection and amplification